Certifications, test reports and declarations — all on the proof hub.
Silicate Systems
Contact
← All systems
Industrial floors

Eco Rapid

Mineral poured floor for parking decks, ramps and industrial floors under vehicle load. A silicate-binder alternative to epoxy flooring.


Where it may be used

Indoor and outdoor, as stated on this system's own data sheet. Use elsewhere is not covered by that sheet.

Application temperature: +2 °C.

Thickness range: 2 to 50 mm.

Substrate must be sound and free of loose material, with a pull-off strength of at least 1.5 N/mm². The chemistry is consistent; what the floor becomes depends on the substrate, the specification and the applicator.


Declared for this system
EMICODE EC1PLUS — very low emissionEPD verified

VOC- and APEO-free is declared for Eco Sil, Eco Flex All In One and Eco Shield only, so it is not claimed here. BREEAM, DGNB and LEED contribution is documented per project, not per range.

Walkable in four hours means light foot traffic at 20 °C. Full operational load is four days indoors and seven days outdoors.


Data sheet figures
Eco Rapid. Figures from the published technical data sheet.
PropertyValueStandard
Strength classCT-C50-F10DIN EN 13813
Compressive strengthapprox. 50 N/mm²DIN EN 13813
Flexural strength> 12 N/mm²DIN EN 13813
Wear resistanceBöhme A9DIN EN 13892-3
Water tightnessup to 1.5 bar—
Chemical resistanceGood chemical & saltwater resistance—
Slip resistanceR10 (without quartz sand) / R13, V8 (with quartz sand)—
Application thickness2 to 50 mm—
Consumptionapprox. 1.8 kg/m² per mm layer—
Mixing ratio4.5 L water / 25 kg powder—
Processing temperature+2 °C to +35 °C—
Processing timeapprox. 25 min at 20 °C—
Walkableafter 4 hours—
Fully loadableafter 4 days—
AntistaticDIN EN 61340-5-1DIN EN 61340-5-1
Emission classEMICODE EC1PLUSGEV

Projects using this system

Documents

/systems/eco-rapid